Home » Products » Sewing Accessories » Sewing Machine Feet » Snap on – 3⁄4 Inch (2cm) Hemming Foot

Snap on - 3⁄4 Inch (2cm) Hemming Foot

£4.95

In stock

Sewing bee fabrics haberdashery and ribbons

Description

This sewing machine foot works the same way as the rolled hem foot, but the width of the hem created will be 3⁄4 inch (2cm). We recommend that you start your hem off by first folding the first ½ inch (1cm) by hand. Do this by making a small fold that is the width of your guide. Next, fold that under again so that the raw edge is enclosed. Put it underneath the foot and sew a few stitches to secure the fabric and fold it in place. Now leaving the needle down but lifting the presser foot up, thread the edge of the fabric into the guide. Lower the presser foot back down and stitch in place while keeping a slight tension on the fabric edge and curling the fabric as you go to help feed it through. Make sure to keep the fabric central or it can slip out of the guide.

Universal Snap-on Feet will attach to low or high shank sewing machine adapters, which covers a wide range of both home and domestic sewing machines. If you aren’t sure if this will fit your machine, check out our sewing machine feet guide.

 

Recommended ReadingSewing Machine Feet Guide

Additional information

Colours

Sewing Machine Fitting

All fabrics will be cut as a continuous piece unless you ask us otherwise. In the unlikely event this isn’t possible we will always contact you first. 

Our fabrics are all hand cut with care, never torn.

We recommend that all of our fabrics are washed at 30°c or below to improve fabric durability and colour vibrancy.

We try to match the colours in our photos as closely as possible but some differences may occur.

Size Guide & Conversion

1 Metre = approx. 39  Inches

Half Metre = approx. 19 ½ Inches

Fat Quarter = approx. 50cm x 40-50cm

(approx. 19½ Inches x 15 ¾ – 19½ Inches)